I’ve used polulo servo controllers before, and I love them; but I’m no expert. I just tried to get into it again, and I’m blocked.
6 channel servo controller. I tried plugging an old one back in, and no servo responds. I opened another 6 channel board from the package, and the same symptoms.
I can connect to the board, green light and yellow light (single yellow blink with nothing, double blinking light with a servo plugged in, nothing more than double blink). I thought maybe I was using a power usb cable, but I bought a data cable specifically, no change. I’ve tried changing the baud rate, no change.
Shifting the sliders, and no reaction from a servo at all.
Is there something I’m missing?
Thank you
2 posts - 2 participants
